Jump to content

ashmk3

Members
 View Profile  See their activity

  • Content Count

    687

  • Joined

  • Last visited

 Content Type 

Everything posted by ashmk3

  1. ashmk3
    Yep used to have some on my old mk3. I paid £70 plus delivery for a second hand replacement set on eBay after some nunce reversed into mine. Were Hellas tho.
  2. ashmk3
    Well put it this way an facelift arosa and lupo are the same car and I'm using a arosa steering wheel boss and fits spot on. I have also had my girlfriends steerin wheel off her lupo to replace the indicator switch and the airbag plug is identical to the mk3 one. So all in all I don't see why the steering wheel shouldn't fit.
  3. ashmk3
    7.5j but I want to run pretty low still hence the low profile.
  4. ashmk3
    I would also like to know this would be a good info thread. I'm not sure if it's just the calipers or if it's mk4 discs and mk4 bearings or if there all the same. Also what hoses to use as good ridge sell a kit for the mk3 specifically for mk4 rears and 312mm fronts.
  5. ashmk3
    So does it work now then
  6. ashmk3
    Looking at getting 17s but the size tyres I want I can only find nankang ns2. Has anybody used these and how do they perform. The size I want is 185 35 r17. Small amount of stretch but not a stupid amount.
  7. ashmk3
    Right disc all off and sensor and ring cleaned cleared fault went for a drive and on comes the light. And Craggsy did say that his was always the rear right so it looks like a new module as the one I have was his old one. So if anyone has one let me know.
  8. ashmk3
    Just took it out for a drive and it came on as I pulled up so it's not the magnet that was left from the last sensor. Will try the ring and give it a wire brush too.
  9. ashmk3
    Just taken the wheel off and looked behind the disc and there was a magnet stuck to the inside shoulder of the disc and looks like that may be why I was getting the like coming on every now and again rather than all the time. As it looks like it has got stuck to the new sensor and dragged on the ring.
  10. ashmk3
    Funny you mention discs when I got the car the handbrake wasnt engaging on one side so I removed the caliper and freed the piston up and the handbrake mech. Now that works perfect but I did notice that the abs ring was able to move without much force around where it sits and I can move it back and forth. This may be the issue then as when I switch wires over it does indeed change sides. I have just finished work so will have a look won't I need new bearings if I take the disc off?
  11. ashmk3
    How close should the rear sensors be to the ring. As my rear right sensor keeps cropping up even after a new sensor. But when I removed the old one it was almost touching and so is the new one but i can't see anyway to adjust it. The fronts are about 3-4mm away but the rear right you can hardly see light through the gap. And I couldn't get the left side shield off to have a look in comparison. If any one has a picture that would be great.
  12. ashmk3
    Nice one cheers. I'll pop down after work, I managed to find a thread about fitting a momo boss and the two wires and fuse match. Maybe now I have plugged the light in I need to reset it on vagcom ?
  13. ashmk3
    Right I have just fitted my deep dish steering wheel. And fitted my abs/ airbag light, now the light I thought would be on was abs but not that's fine it's the airbag one. Now the boss kit isn't a mk3 one it's from a seat arosa as my mate said if it fits I can have it. But are the resisitor or the fuse the wrong one? It's a 2 amp small fuse.
  14. ashmk3

    STOLEN

    ashmk3 replied to ashmk3's topic in General Chat

    I'm guessing it was stolen to order. Probably a survalence job but didn't see the CCTV. They did have crow bars just incase anything was locked etc or to scare anyone should they of been approached.
  15. ashmk3

    STOLEN

    ashmk3 replied to ashmk3's topic in General Chat

    Cheers mate, it was south Manchester, looks like they pulled up in a black corsa.
  16. ashmk3

    STOLEN

    ashmk3 replied to ashmk3's topic in General Chat

    The front door to the house was unlocked as they were all in. The guys opened the door found the keys and drove off. If you watch the video it shows it all mate.
  17. ashmk3

    STOLEN

    ashmk3 posted a topic in General Chat

    A friend of a friend from manchester has has their Audi s3 stolen in broad daylight and they were in at the time. There is a video from the CCTV hopefully this works if you can all post it around other forums and Facebook and twitter it would be much appreciated. I cant seem to copy the video off of Facebook but if you search for me ( Ashley Bradshaw) my pic is a grey mk3. The video is on their. Chris rustage is who the car and video belongs to.
  18. ashmk3
  19. ashmk3
    I set my coilovers on the mk2 with half a tank of fuel. So it wasnt too low with a full tank but not sky high with an empty tank.
  20. ashmk3
    I can't believe the attention to detail. I think I may do this with the mk3 also what intake is that ?
  21. ashmk3
    No worries try and help when I can. If I'm wrong I'm sure someone else will say
  22. ashmk3
    http://www.a2resource.com/electrical/CE2.html http://www.a2resource.com/electrical/management/motronicvr6aba.html Both of those have helped me a great deal when I did the mk2
  23. ashmk3
    It's needed for obd2 it tells the Ecu where cam 1 is
  24. ashmk3
    if you have the port wired up then i might be able to depending upon work.
  25. ashmk3
    You changed the blue temp sensor? As that effects fueling on choke and off choke. ?
×
×
  • Create New...