j1jon 0 Posted June 1, 2010 Report Share Posted June 1, 2010 when my new wheels go on im goin to lower my VR on coils. Only prob is I know how low VR sumps are :-(is it better to get a sump guard or audi 3.2 sump (Am I also right in thinkin you need a new oil feeder to?)thanks for any help Link to post Share on other sites
Gazbarber1982 3 Posted June 4, 2010 Report Share Posted June 4, 2010 If you get the 3.2 / r32 sump u need the feed for the pump because of the adjusted pickup point. My last VR was low. So low you couldn't get a low profile trolley jack under the front and you had to lift it on the wing to get it under the side. I didn't have much of a problem most of the time but go between speed bumps when it's one on each side of the road and drive at the kerb on an angle to go over the bumps that go all the way accross. Link to post Share on other sites
CALICO 130 Posted June 4, 2010 Report Share Posted June 4, 2010 you could also put spacers in between the engine mounts and the crossmembers to raise the engine a bit but beware of under bonnet clearances Link to post Share on other sites
j1jon 0 Posted June 4, 2010 Author Report Share Posted June 4, 2010 Thanks for that dudes. I'll see what it's like when the wheels are on and take it from there Link to post Share on other sites
VR6Pete 1,455 Posted June 4, 2010 Report Share Posted June 4, 2010 I've got a sump guard for my Corrado Link to post Share on other sites
Recommended Posts