dale p 62 Posted November 28, 2013 Report Share Posted November 28, 2013 right cars been off rd for 2 yrs just being started up in that time ect, ive had few earthing probs which looks like have got to bottom of but took car out for 1st time down my rd and tried to select reverse but nothing then seems stuck in 1st solid now bearing in mind ive also got b&m linkage anyone else come across this scenario before i start taking too much stuff apart,and while this happened it wouldnt fire back up until messed around with earth straps on batt,any advice/ideas be good before i start getting to involved cheers Link to post Share on other sites
dale p 62 Posted November 29, 2013 Author Report Share Posted November 29, 2013 any ideas seems to me more on linkage side Link to post Share on other sites
Reaperx 181 Posted November 29, 2013 Report Share Posted November 29, 2013 (edited) Can you not disconnect the linkage on the box itself or try moving the selector by hand Edited November 29, 2013 by Reaperx Link to post Share on other sites
dale p 62 Posted December 1, 2013 Author Report Share Posted December 1, 2013 The selector won't budge,I'm going to spend day on her tomos,I'm just hoping its all stiff due to not being used Link to post Share on other sites
Reaperx 181 Posted December 1, 2013 Report Share Posted December 1, 2013 My first thing to try would be a shed load of wd40 on it and try wiggle it and free it off. If not could possibly need the box out Link to post Share on other sites
dale p 62 Posted December 1, 2013 Author Report Share Posted December 1, 2013 yes sprayed load on already going to wack some more on in bit too,worst thing is,replaced clutch just about 200mile before taking off the road and the box has been completely rebuilt 12 mths prior,i was just wondering if could be b&m thats caused the prob where box hasnt had much movement Link to post Share on other sites
VR6Pete 1,455 Posted December 1, 2013 Report Share Posted December 1, 2013 Possibly selector tower, they are quite common. Club Chairman Link to post Share on other sites
dale p 62 Posted December 1, 2013 Author Report Share Posted December 1, 2013 Can they just cease up Link to post Share on other sites
Recommended Posts