bigsteve 0 Posted April 9, 2012 Report Share Posted April 9, 2012 Have had some new leads made for vr but now they dont fit in the holder, any ideas on how i can get over this .. and dont stay get different leads please lol Link to post Share on other sites
Daverse 175 Posted April 9, 2012 Report Share Posted April 9, 2012 if your handy with wires (and i dont mean just terminal block it) you could cut them down and recrimp the ends Link to post Share on other sites
craggsy 91 Posted April 9, 2012 Report Share Posted April 9, 2012 Too big as in too thick? Or as Dave says too long?If too thick then just knock the little tabs in the grooves out till they fit Link to post Share on other sites
bigsteve 0 Posted April 10, 2012 Author Report Share Posted April 10, 2012 Sorry yes as in to thick, Link to post Share on other sites
HAMMER_VR6 0 Posted April 10, 2012 Report Share Posted April 10, 2012 I had this problem. I bored out the plastic channels in the lead holders with a small sanding drum on a Dremel, but now I have gone back to standard leads anyway. Link to post Share on other sites
bigsteve 0 Posted April 10, 2012 Author Report Share Posted April 10, 2012 think im going to have to bore them out Link to post Share on other sites
yakuza racer 16 Posted April 16, 2012 Report Share Posted April 16, 2012 I had this problem. I bored out the plastic channels in the lead holders with a small sanding drum on a Dremel' date=' but now I have gone back to standard leads anyway.[/quote']x2!!dremel to the rescue! Link to post Share on other sites
Recommended Posts