kezwaldo 0 Posted March 16, 2012 Report Share Posted March 16, 2012 just got my two front wheel bearings threw post as they are in a bad way and making loads of noise ............just wondered if i would be able to do them myself or is it a real pain?????? Link to post Share on other sites
craggsy 91 Posted March 16, 2012 Report Share Posted March 16, 2012 Its a long job without a press to press them in and out.I have done it before and spent about 4 or 5 hrs getting old one out and new one in Link to post Share on other sites
Daverse 175 Posted March 16, 2012 Report Share Posted March 16, 2012 As above, I think it would be easier to get a garage to press them in and out, would take seconds in a press, hours by hand Link to post Share on other sites
cabrioman 6 Posted March 16, 2012 Report Share Posted March 16, 2012 what they all said ........ Link to post Share on other sites
kezwaldo 0 Posted March 22, 2012 Author Report Share Posted March 22, 2012 rite the wheel bearngs done one was so worn on drivers side it had buggered the flange or something my mate said so had that replaced to drives so much better now ..........got charged 35 quid a side and i supplied the bearings 13 quid each off ebay from volksbits in birmingham fast good service from there Link to post Share on other sites
Recommended Posts