Just_Paul 0 Posted March 30, 2010 Report Share Posted March 30, 2010 Hi guys, sorry if this is a repost, but i cant see it anywhere... i have a fair amount of rust on the bottom rear of my o/s wing, and a fairly small amount in the same place on the n/s.o/s has gone right through, not much left of the bottom couple of inches, and basically, would that be an MOT failure (if i tape up the sharp edges for now)?unfortunately, the snow made it much worse, but i havnt got any more recent pictures; but you get the idea: Link to post Share on other sites
VR6Nat 9 Posted March 30, 2010 Report Share Posted March 30, 2010 Yeah i think that will be mate... looks nasty!! Best bet is to try n scrape together the dough to do it or it will only get worse... :( Link to post Share on other sites
legvw 0 Posted March 30, 2010 Report Share Posted March 30, 2010 Why not just chuck a second hand pair of wings on, just for the mot. Have you checked your sills? Near the front? If your wings look like that, i'd check them just to be sure. Link to post Share on other sites
Just_Paul 0 Posted March 30, 2010 Author Report Share Posted March 30, 2010 cool, thanks guys, i was hoping to get some new pattern onews sprayed in, when iget a couple of other bubbles done, did think of grabbing a second hand pair too.. had a quick poke about arond the seal, doesnt look too bad, it was the mud flaps that did this! Link to post Share on other sites
CALICO 130 Posted March 30, 2010 Report Share Posted March 30, 2010 gaffa tape over it for the mot as its a highline the sills arnt covered by plastic so i wouldnt have thought theyd be that bad Link to post Share on other sites
Rikki 2 Posted March 31, 2010 Report Share Posted March 31, 2010 not really a fail as its not structural. but some tape may be good if its sharp edges Link to post Share on other sites
Recommended Posts