dash board

[terry_vr6 0]

hi does any1 no or have a diagram how 2 get dash board out as need 2 change the clocks??? cheers

[richievr 1]

easy mate..

pop out the blank on right hand side (no1 above)

on end of headlamp switch is a press in clip. press it in. switch comes out.

pop out the blank on left side (no3 above)

remove 2 screws arrowed above holding the surround in

surround will now pop out.

2 screws will now be visible that hold in the dials..

undo, lean dials forward, unplug loom and remove..

job done with minimal swearing hopefully *-)

[terry_vr6 0]

cheers buddy my mate got told there a nightmare today as he got same problem as me with clocks but see how it goes 2mo morning

[richievr 1]

naaah, easy mate! even i can do it!!!

if you have never done it before be careful not to break anything levering them out of the dash, a small flat blade driver will be fine.. just prise carefully.

should take about 15 mins if, as i say, you have never done it before.

putting it back together will much easier, will take about 2 mins

[terry_vr6 0]

nice one cheers mate will let u know how it goes to mo mate

[terry_vr6 0]

done the clocks to day wasnt to bad apart from sum1 had already been at it and not put right screws in the wholes lol everythin works but temperture gage goes sraight up to temperture is there a reason for this? cheers ash

[richievr 1]

see, told you it was easy.. (h)

but i don't know why your temp guage does that, sorry..

[Rikki 2]

could be the yellow (if you have ac could be diff colour if not) sensor on the front of the thermo housin. that controls the gauge

[richievr 1]

good shout!!

[terry_vr6 0]

ok cheers guys will check that

[terry_vr6 0]

were abouts it the thermostat

[richievr 1]

here you go..

arrowed in the below picture.. you can just see the 3 switches

the 4 pin one does the temp gauge. :-d

[terry_vr6 0]

cheers mate hope thats all it is