Jump to content

Recommended Posts

I have 8 x 17's on my VR with 215/40/17 Toyo's on. When it was lowered about 40 mm, I did get a very small amount of rubbing on the rear of mine (although a golf and Jetta's rear arches may differ?)

But now have a serious drop on it ( Lot lower than in the sig!)and had to have the rears and the fronts rolled/trimmed and pulled to accomadate them. Still get a very slight rub on the front on full lock, but anyone who's seen the car will tell you its seriously low now!

I'm running an et35 on my rims and this is the main thing your going to need to worry about as you'll need adaptors for Merc stuff. I too have been looking at 16" Merc rims to replace my RH's but having a bit of grief getting the offset I want to run.

[ Edited Sat Aug 28 2004, 02:25PM ]

Link to post
Share on other sites

i've been looking for a set of 16" amg merc rims to, saw a set a while back, needed totally done up but were going cheap but had no cash and i really do mean none so couldn't buy, haven't seen a set again and thats been 6 months, would have looked amazing

Link to post
Share on other sites

i was looking at some flat ones, looked a bit like these; http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&category=10398&item=2487203629&rd=1

but they were not split rims and the 5 spokes were thicker. didn't go for much but would look amazing polished up. am going for design 90's now, didn't want to as wanted something different ut have settled for them

Link to post
Share on other sites
×
×
  • Create New...