simey 0 Posted July 21, 2004 Report Share Posted July 21, 2004 My charger belt has shreaded its teeth and has been cut off to avoid further damage.The question I'm asking is what size belt you are using for the Z Engineering 2 s/c? i.e. Dayco 500 RPP 5 20 Link to post Share on other sites
VR6Pete 1,455 Posted July 21, 2004 Report Share Posted July 21, 2004 ahh! so that's your belt i saw today at stealth? Link to post Share on other sites
ingham 5 Posted July 21, 2004 Report Share Posted July 21, 2004 surly any good parts place should be able to get one,as you have size and teeth number and size of teeth Link to post Share on other sites
mightyvr6 0 Posted July 21, 2004 Report Share Posted July 21, 2004 Not sure on the size but it says 113 on the belt if that means anything.nsracing sell them for £25are the teeth on your impeller pulley a bit worn? Link to post Share on other sites
simey 0 Posted July 21, 2004 Author Report Share Posted July 21, 2004 ahh! so that's your belt i saw today at stealth?The cut belt with no teeth, that'll be the one........ Link to post Share on other sites
simey 0 Posted July 21, 2004 Author Report Share Posted July 21, 2004 I was just curious what size belts are on other s/c as I've found out that the belt isan't an automotive belt but an indudtrial one.Just seen if anyone else has come across this.Belt arriving tommorrow so should be ok for Castle Coombe Link to post Share on other sites
Recommended Posts