Luke 0 Posted December 18, 2006 Report Share Posted December 18, 2006 I have found a possible high mile donor car to put my vr back to it roaring self again(i hope) :S The car im looking at buying is an 94 OBD1 3dr & was wondering if all the bits i need off it to repair mine will fit? I have an 96OBD2 3dr Basically what im trying to say is will the hubs,drive shafts,complete rear suspension beam,wishbones, etc... mate up to my OBD2??? Eny feed back would be great guys n girls as im getting desperate now & thinking bout giving up on my vr all together :-( Link to post Share on other sites
mike 6 Posted December 18, 2006 Report Share Posted December 18, 2006 i think the brakes are slightly smaller on early obd1 vr's (might just be the front)but everythin else sgould b the same, dont give up mate Link to post Share on other sites
petervr6 0 Posted December 18, 2006 Report Share Posted December 18, 2006 aint the early vr6 4stud aswell? Link to post Share on other sites
richievr 1 Posted December 18, 2006 Report Share Posted December 18, 2006 it should all fit fine mate .the rear end is definately all the same , the front end will be the same apart from the brakes - you will need to use your existing calipers and carriers and disks...all the wishbonea, arb's, driveshafts etc will all mate up no worries .... and NO THE EARLY VR'S ARE NOT 4 STUD........ go for it - !! good luck Link to post Share on other sites
petervr6 0 Posted December 18, 2006 Report Share Posted December 18, 2006 ok yep good luck with it mate. Link to post Share on other sites
gav_113 0 Posted December 18, 2006 Report Share Posted December 18, 2006 mines a 92 and its 5 stud, brakes are 280s late ones are 288s. Link to post Share on other sites
Recommended Posts