i-ninja 0 Posted December 5, 2006 Report Share Posted December 5, 2006 Hey!Im going to turbo the vr in the new year, I plan on moving the battery to the boot to make space for the i/c piping. Whats the best way to do this? Also would the standard battery be ok in the spare wheel well?Stuart. Link to post Share on other sites
FishWick 21 Posted December 6, 2006 Report Share Posted December 6, 2006 Yeah that's where mine is. Perfectly fine. Just remember to strap it down. You don't want that hitting you in the head!Run some 0 gauge under the carpet and terminate it in the engine bay to the stock wiring harness. The 0 gauge earth needs a substantial mounting point in the trunk, something like a rear seatbelt mount etc.....but not self tapped to thin sheet metal!Where you pass the wire through the bulkhead, I would use a compression gland rather than a grommet as they are much tougher. You can get them from B&Q.Fuse both ends of the cable (battery end and engine bay end) in case the worst happens....and use 150 amp fuses because of the starter motor current draw. Link to post Share on other sites
ingham 5 Posted December 7, 2006 Report Share Posted December 7, 2006 it is best to put battery in box for safety if inside car ,most rally prep places do them (and make sure that they are well bolted down) Link to post Share on other sites
cadguy77 0 Posted December 7, 2006 Report Share Posted December 7, 2006 does anyone do a relocation kit? Link to post Share on other sites
antera309 3 Posted December 8, 2006 Report Share Posted December 8, 2006 Not aware of any kits as such, but you can always get the complete wiring setup from a car that has the battery in the boot as standard. Any 6-cylinder E36 3-series BMW is ideal. Link to post Share on other sites
RIX 0 Posted December 10, 2006 Report Share Posted December 10, 2006 audi 80 avant has bat. in the boot,ore at least the s2 model Link to post Share on other sites
FishWick 21 Posted December 10, 2006 Report Share Posted December 10, 2006 Doesn't need to be in a box at all. This is what's in mine. Proper mount made for it etc, which due to the batt's light weight, just simply needs screwing to the floor. Link to post Share on other sites
Recommended Posts