rooneyharper 1 Posted April 28, 2006 Report Share Posted April 28, 2006 I am looking to polish my inlet manifold soon. I am going to take it off to do this, how do you do it... and is there anything i need to be aware of that could potentially spell disaster ... ??? Link to post Share on other sites
Buzzark 0 Posted April 28, 2006 Report Share Posted April 28, 2006 I'm guessing you're polishing the outside as we're in bodywork and styling. Nothing too dangerous about it, it's just a lump of soft metal. I'd get the ends sealed up before starting if I were you, but even then it can always be cleaned inside if some dust gets in. You'll probably want to clean it when it's off anyway. Link to post Share on other sites
c4mbl 1 Posted May 17, 2006 Report Share Posted May 17, 2006 Stockers has posted a detailed step by step guide how to do it mate. Just a few threads up the page from this one. Link to post Share on other sites
Recommended Posts