jezmoz 0 Posted February 15, 2006 Report Share Posted February 15, 2006 The other week i couldn't get the gears to change, took it to a garage and he said the clutch pedal wasn't disengaging the gears and pointed to how low the clutch pedal was, he bled the clutch (pumped liquid through it with the pedal whilst his colleague fiddled with what i'm assuming has something to do with the clutch (a tap/nipple that liquid poured out of). Today i got in the car and was struggling to change gear smoothly again, so i pulled over and the clutch pedal was very low so i pulled it up with my hand, drove off and it worked fine again?? any ideas? Link to post Share on other sites
bazz780 0 Posted February 15, 2006 Report Share Posted February 15, 2006 clutch cable sticking? if VR6 has one, Link to post Share on other sites
jezmoz 0 Posted February 15, 2006 Author Report Share Posted February 15, 2006 it's hydraulic Link to post Share on other sites
fabio_vr6 0 Posted February 16, 2006 Report Share Posted February 16, 2006 replace the clutch slave cylinder and the master cylinder if u where u Link to post Share on other sites
kilokilla 0 Posted February 16, 2006 Report Share Posted February 16, 2006 yes indeed either your slave in gearbox or master cylinder on bulkhead is leaking and needs replacing mate. Link to post Share on other sites
jezmoz 0 Posted February 16, 2006 Author Report Share Posted February 16, 2006 do gsf do these??? How much are we talking?? Link to post Share on other sites
Ciaran 4 Posted February 16, 2006 Report Share Posted February 16, 2006 could be the clip on top of the pedal on it's way out!!! Link to post Share on other sites
Recommended Posts