Jump to content

Recommended Posts

I'm sure that's the lower support for the selector tower shaft, item 25, doesn't show a seal on the diagram though but thought there was an 'O' ring on it, a red one 25mm or so.... but stand corrected on that - it's sealed with the 'sealing paste' AMV18820003. There's certainly an 'O'ring on each of the bolted tabs by it, they're 14mm dia and on the diagram as no 27.

image.thumb.png.73d25d1366945b4fd144ca16410128a4.png

tampa-alavanca-seletora-vw-02a301252d-D_NQ_NP_319401-MLB20343371733_072015-F.jpg

Edited by chalkyh
extra infos
Link to post
Share on other sites

Can't see it causing a problem, you will need to drain the oil and I'd put the gearlever into a forward plane (like any of 1st, 3rd, 5th gears) so it lifts the shaft 8 up a little. I can't guarantee any of the selector levers will drop - they shouldn't but you never know. Alternatively, just release the bolts a few threads, good solvent clean and get some sealer in there - with the oil drained.

Edited by chalkyh
extra info
Link to post
Share on other sites
×
×
  • Create New...