dom.joy 87 Posted September 21, 2015 Report Share Posted September 21, 2015 Apologies for another new thread. I would like to make up replacement intakes for my Vortech V1 charger, the ones with the kit will work but look a little home made.I am looking to use silicone and alloy hoses to do this. My question is has anyone done this before and would know off hand what bends etc are required before I sit and try to work it out. I am so far thinking TB>90 deg silicone>straight alloy>45 deg silicone>chargerThen Charger>90 deg 100-76 reducer>straight alloy>silicone joiner>MAF>filter. This is just from looking at some photos and not using the intakes as a base.Cheers Link to post Share on other sites
Recommended Posts