paceo 22 Posted November 19, 2013 Report Share Posted November 19, 2013 as title, are the inlet manifolds the same?? Link to post Share on other sites
CALICO 130 Posted November 20, 2013 Report Share Posted November 20, 2013 Throttle bodies are different as are the bolt holes for the throttle body onto inlet mani. Link to post Share on other sites
paceo 22 Posted November 20, 2013 Author Report Share Posted November 20, 2013 Throttle bodies are different as are the bolt holes for the throttle body onto inlet mani. thaks buddy, what about water pipes etc?? are they all the same? well they looked the same! IF i get this obd2 turbo ill sell all the pipes etc........... Link to post Share on other sites
CALICO 130 Posted November 20, 2013 Report Share Posted November 20, 2013 Not sure to be honest Pete (chairman) should be able to tell you as he changed his Raddo from obd1 to obd2. Link to post Share on other sites
paceo 22 Posted November 20, 2013 Author Report Share Posted November 20, 2013 Not sure to be honest Pete (chairman) should be able to tell you as he changed his Raddo from obd1 to obd2. thanks buddy, the wiring change is going to be an issue as i think the abs is spliced into the engine loom also. obd1 and 2 run a different abs pump Link to post Share on other sites
Power-Project 0 Posted November 25, 2013 Report Share Posted November 25, 2013 Hi there a are a few differemces in the 2 obd1 has isv out and has smaller throttle body and blts different were as obd has bigger throttle body and no isv also the inlet insides have better flow Link to post Share on other sites
Recommended Posts