vr6mike 0 Posted January 19, 2012 Report Share Posted January 19, 2012 i have just had the flywheels lightened only 2kg off it and have just brought a 6 paddle clutch as i am putting a charger on it . started it up today and went to move it and the clutch is really high right at the end is this a problem or is it something else ?????? i have bleed ut the slave but its all good and the peddle feels fine also all the clutch etc.... went in no problem any ideas? thanks Link to post Share on other sites
Daverse 175 Posted January 19, 2012 Report Share Posted January 19, 2012 Have they skimmed the flywheel? if so then its got thinner sothe clutch has got to travel further? thats my opinion anyway could be wrong. Link to post Share on other sites
cabrioman 6 Posted January 19, 2012 Report Share Posted January 19, 2012 if they did skim it then should have skimmed the face and the edge where it bolts to by the same amount .... Link to post Share on other sites
vr6mike 0 Posted January 19, 2012 Author Report Share Posted January 19, 2012 yeah they did, it was done by rowe enginering in fleet they do loads and it was only a light face skim and then lightened from around the edge Link to post Share on other sites
Recommended Posts