Jump to content

Recommended Posts

Got a problem with my 96 vr , vcds says fault on maf but i have tried a different one and it made no difference, the symptoms are the engine nearly dies as the idle speed goes so low after cold start, as the temp increases then idle speed returns to near normal but still a bit low, then i get random times when rpm fluctuates between 2500 and 800 if coming up to junctions etc when not under any load.On the vcds readout there is a fault code for a solenoid valve which on most of list of codes i have found says that it relates to auto gearbox which i dont have.Before i started the engine i ran vag com and it said coolant temp was 27 degrees which could indicate faulty temp sensor, but would that in turn give the erratic running?

here is the vcds log if any one can shed any light on it!

Saturday,31,December,2011,14:38:55:36351

VCDS Version: Release 11.11.1 (x64)

Data version: 20111209

--------------------------------------------------------------------------------

--------------------------------------------------------------------------------

Address 01: Engine Labels: 021-906-256.lbl

Control Module Part Number: 021 906 256

Component and/or Version: MOTRONIC M3.8.1 HS V02

Software Coding: 00000

Work Shop Code: WSC 01111

VCID: CFA70AEF0DC68C1

3 Faults Found:

00553 - Mass Air Flow Sensor (G70)

31-10 - Open or Short to Ground - Intermittent

00268 - Solenoid Valve 6 (N93)

28-00 - Short to Plus

00553 - Mass Air Flow Sensor (G70)

28-10 - Short to Plus - Intermittent

Readiness: N/A

--------------------------------------------------------------------------------

--------------------------------------------------------------------------------

Address 01: DTCs cleared

--------------------------------------------------------------------------------

--------------------------------------------------------------------------------

Address 08: Auto HVAC Labels: 1H0-907-044-A.lbl

Control Module Part Number: 1H0 907 044 A

Component and/or Version: CLIMATRONIC V 21

Software Coding:

Work Shop Code:

VCID: 2241135BAED4D19

2 Faults Found:

00796 - Fan for Interior Temp Sensor (V42)

35-00 - -

01274 - Air Flow Flap Positioning Motor (V71)

35-00 - -

Link to post
Share on other sites
  • 10 months later...

Fitted a genuine VW temp sender and sealed an air leak on the intake ducting where the engine breather pipe joins the main duct, seems to have been ok since. Just discovered that electric secondary water pump hasn't been working so i have that to sort out now!!

Link to post
Share on other sites
  • 3 weeks later...
×
×
  • Create New...