VeedubVR 0 Posted December 4, 2011 Report Share Posted December 4, 2011 smoothing the bay and unsure whether to run through the chassis legs or behind the wings..... but either way the looms are going to have to be extended.Anyone done this? Is it easier to buy another loom and extend the orig using the second one? Will drivers side have to be extended at all? the loom for the headlights seem to run above the chassis leg..... Link to post Share on other sites
lumoxs 0 Posted December 4, 2011 Report Share Posted December 4, 2011 Ha I have done this, and from experiance i would suggest you get another loom to use, so you can use the same colorband ohm wiring... And only cutband extend 1 wirevat a time unless you want to be like me and do endless amounts of back tracking to find out what you've done wrongI have run my headlight loom down the wing (drivers side) and the engine loom down the passenger chasis leg and located the ecu inside of the car behind the centre console Link to post Share on other sites
VeedubVR 0 Posted December 4, 2011 Author Report Share Posted December 4, 2011 Right pain of a job? How much you reckon it needs to be extended? Link to post Share on other sites
lumoxs 0 Posted December 4, 2011 Report Share Posted December 4, 2011 Will need a good 2/3ft of extending for the headlight loom n engine plug loom, if u have a soldering iron.... Use it took me best part of 2 days 2 cut n extend!!! Link to post Share on other sites
Recommended Posts