ollie_ 0 Posted January 13, 2011 Report Share Posted January 13, 2011 Afternoon all! I'd quite like to shorten my gear stick but still use the original knob and gaiter, so obviously I need to put another thread on.Anyone any idea what size thread it is? So I can get the right size tool ta! Link to post Share on other sites
editionmatt 1 Posted January 13, 2011 Report Share Posted January 13, 2011 It sounds wrong but I just cut mine down put a small amount of insulation tape round the top and used a rubber mallet to bang it back in place. It's not going anywhere! Me being lazy but it saves faffing round with a threader! Link to post Share on other sites
ollie_ 0 Posted January 13, 2011 Author Report Share Posted January 13, 2011 Interesting little bodge haha!May give that a try, guess it's a bit rubbish if you actually want it off though? Link to post Share on other sites
editionmatt 1 Posted January 13, 2011 Report Share Posted January 13, 2011 it will come off, will just need a little elbow grease i was originally gnna thread mine but i just did the insulation tape thing as a temporary measure and it worked so well i didnt bother threading lol Link to post Share on other sites
Baz 0 Posted November 5, 2011 Report Share Posted November 5, 2011 Hi Ollie,Did you get a reply about the gearstick thread ?I want to do the same to mine & think it may be a M12x1.0 but want to be sure.Baz Link to post Share on other sites
Recommended Posts