rob_skater 0 Posted February 19, 2010 Report Share Posted February 19, 2010 So im half way through my rebuild and i have kept the engine in the car because i did not have the money to buy an engine stand and i also thought i wouldnt need to be doing too much work, but id finished with my head, new seals, bit of a cleanup n that, and i go to put it all back in and i realised i needed to replace both upper chain gide rails as one had snapped and the other was broken by me My question is, is there and easier was to fit the upper tentioner guide, the one that is on a pivot?I am just about to start to take the box,clutch and fly wheel off so i can get to it Do you recon i sould get away with just leaving the shafts attached and also hydro clutch and cables? whilst sitting it on the floor ? Link to post Share on other sites
ingham 5 Posted February 19, 2010 Report Share Posted February 19, 2010 http://forums.vwvortex.com/zerothread?id=1264409 Link to post Share on other sites
VR6Pete 1,455 Posted February 19, 2010 Report Share Posted February 19, 2010 There's plenty of guides in our premium members section for this sort of thing. Link to post Share on other sites
rob_skater 0 Posted February 19, 2010 Author Report Share Posted February 19, 2010 I must have read that thing three times now, but cheers mate, it looks like that is the only way round it im still wondering weither i will have enough room to just lay the box on the floor with it all linked up still tho ? Link to post Share on other sites
Recommended Posts