scoot spanker 9 Posted September 28, 2009 Report Share Posted September 28, 2009 I'm going to be replacing my starter motor this Saturday (well removing it) Is this a fairly straightfoward job that I can do on a driveway? If someone can give me a rough guide that would be great Link to post Share on other sites
Timah89 1 Posted September 30, 2009 Report Share Posted September 30, 2009 Straight forward 1hr job groveling under the front end of the car undoing bolts which hold starter to bell housing. Much easier than on 4cyl 8V where starter mount includes front engine mount. Just make sure that phosphor bronze pinion bush stays in housing or if it comes out you replace it.Good luck Link to post Share on other sites
Recommended Posts