polo_vr6 0 Posted August 9, 2009 Report Share Posted August 9, 2009 hi guys i have just finished building my vr6 polo and have found when she hits 3k the oil light comes on the dash also beeps and flashes but when i turn her off and back on the beep and light stops till she hits 3k again then its back! she has no problem staring or revin right 2 top revs so whts the problem? cheers Ash Link to post Share on other sites
cabrioman 6 Posted August 9, 2009 Report Share Posted August 9, 2009 change the wires over on the oil pressure sensors and see if that fixes it .... Link to post Share on other sites
polo_vr6 0 Posted August 9, 2009 Author Report Share Posted August 9, 2009 ok mate thanks will try in the morning Link to post Share on other sites
The Monk 50 Posted August 11, 2009 Report Share Posted August 11, 2009 Yes mate. I had this problem. It is the oil pressure sensor.Eiher the sensor spade conector has snapped off OR the sensor connectors need to be switched. Link to post Share on other sites
polo_vr6 0 Posted August 13, 2009 Author Report Share Posted August 13, 2009 changin them over made no difference still had a oil light flashin and buzzer was going plus done a oil pressure check and she is lush! im confussed! can i not just rip the wires off and have a oil pressure gauge insted? it would b alot better as i would b able 2 see before hand if theres problems Link to post Share on other sites
polo_vr6 0 Posted August 13, 2009 Author Report Share Posted August 13, 2009 anyone tell me were i can find a place on the internet to buy a new high oil pressure sensor? cheers Link to post Share on other sites
Recommended Posts