supadupagt4 0 Posted May 9, 2009 Report Share Posted May 9, 2009 Hi guys...Is there a write-up for doing the head gasket on an obd2 engine converted to run with a dizzy?thanks. Link to post Share on other sites
Bobtrude 0 Posted May 10, 2009 Report Share Posted May 10, 2009 dont think so, but wouldnt the important part just be to time the engine right. And screwing the bolts in the right order. Link to post Share on other sites
The Monk 50 Posted May 12, 2009 Report Share Posted May 12, 2009 I've got lots of piccys from when I sorted mine out, but there are a few steps missing....eg, cleaning the mating surfaces of the block, head and cleaning the piston crowns of carbon.....I have a coil pack though, non dizzy. I may start a write up of it later and post one in a few days. If you're not in any hurry.As stated though, making sure the timing is correct is the only real issure and making sure the dizzy cap goes back on the same way and position it came off, Link to post Share on other sites
thegoth 5 Posted May 12, 2009 Report Share Posted May 12, 2009 I'm pretty sure the dizzy cap is keyed so it will only fit on one way. Link to post Share on other sites
Recommended Posts