oil cooler

[pat19581 0]

i was replaceing my oil cooler the 2 water pipes that come out of it one goes into the engine block the other goes to the plastic coolant pipe which runs along the front of the engine. as i was taking this pipe of it snaped (connection stub on the plastic collant pipe) does anyone know how the plastic coolant pipe which runs along the front of the engine comes out so i can replace it with a new one i have undone 2 bolt on the right hand side so its loos one end how does the other end come out

[ingham 5]

if you take off the thermostat housing on right it should pull out (fit new thermostat at same time if i were you)

a pic of metal verson

http://store.blackforestindustries.com/vr6crackpipe.html

i hope this helps

[pat19581 0]

its not the thermost end i need to get off its the other end up by the alternater