euro vr with vento front end

[jonny6 0]

Decided to change to a vento front end, looks more aggressive imo , Bit more individual aswell , i also plastic welded over the fogs and indicators in front bumper , quick skim of filler and its good to go. Im really happy with the end result , Job is top notch, you would never know , save me $$$$ to

[tubby 0]

Nice work dude loving the schmidts

[binliner 0]

Looking good (even if you say so yourself ) where did you relocate the indicators?

[jonny6 0]

tapped into the bk of the headlights for indicators

[orangecruz 0]

i also have the vento front end how did u go about smoothing the bumper how did you plastic weld it

[mike 6]

looks really smart that, well done

[J5KE F 0]

Top job chap! also lovin the schmidts

[Phat VR6 3]

Realy nice motor. smoothed bumpers coming my way when i can aford a compressor lol. Another one also lovin the schmidts, need to get rid of my wheels and get some wide 16s

Have you rased the bonnit at the back?

[craggsy 91]

Nice....but I thought indicators need to be in a seperate housing to the main bulb

[jonny6 0]

cut out the fog light recess , bought a cheap rear gti bumper ,cut out two sections to fit into where the foglights were , plastic weld them into position making sure the bumper groove lines up perfectly, fully plastic weld all the way around , sand down welds , skim with filler , high build primer it , paint .

[orangecruz 0]

thanks jonny did it take you long

[jonny6 0]

probably 2 hours each side cutting out foglights and plastic welding new bits in , about 5 hours of filler work , i didnt use hardly any but if you look at the little groove in the front bumper , the groove between the number plate and the fog light is bigger than the groove thatcontinues round towards the front wheel, i hope you understand what im getting at , So basically its just a case of building the larger groove up to match the smaller one .