mike_blackvr6 0 Posted September 16, 2006 Report Share Posted September 16, 2006 Hi, just picked up my new VR, when driving back from the garage (about 70 miles) the brake warning light on the dash came on, checked the brake fluid level and this seems fine and taking the handbrake on and off doesn't seem to clear it but when I switch the ignition off and then on again it seems to dissapear for a while...Any ideas?Cheers,Mike Link to post Share on other sites
badboyV6 4 Posted September 16, 2006 Report Share Posted September 16, 2006 brake pads low Link to post Share on other sites
badboyV6 4 Posted September 16, 2006 Report Share Posted September 16, 2006 is it the circle with the dashed brackets around it?Or do you mean the exclamation mark? Link to post Share on other sites
mike_blackvr6 0 Posted September 16, 2006 Author Report Share Posted September 16, 2006 It's the exclamation mark, same as when you have the handbrake on, in the manual it states that this is either handbrake on or low brake fluid level....By the way how do you get to the bulbs for the ABS and Airbag warning lights as my ABS light is smashed and I can't get to it to get it out, i've pulled the white block out of the dash but cant get to the actual bulb...Cheers Link to post Share on other sites
Ciaran 4 Posted October 6, 2006 Report Share Posted October 6, 2006 mine does this to weird.i find it clears if play with the hanbrake lever think it's the switch under the actual handbrake lever cos iv checked the float sensor in the resevoir cap Link to post Share on other sites
Recommended Posts