Jump to content

CanadianVR6

Members
 View Profile  See their activity

  • Content Count

    11

  • Joined

  • Last visited

 Content Type 

Everything posted by CanadianVR6

  1. CanadianVR6
    Ive been searchin for ages for somewhere in scotland to do my tracking and especially the camber since lowerin my VR. Tons of places will do the tracking, but the only place i could find that has the equipment to do the camber is kwik fit, i believe only 2 of them do it, one on dundee st, in edinburgh and one in paisley. But im hesitant to take my car to them.............
  2. CanadianVR6
    Actually, let me rephrase that the bearing is sitting directly on the spring cap, and theres a nut holding the bearing on..it looked like there was a race machined on the dampner shaft for a bearing,
  3. CanadianVR6
    ya there is, so im assuming ive got it assembled correctly then.
  4. CanadianVR6
    Ya, changed top mounts and bearings...It sounds as if the springs ar turning on the dampner or somthing, if that makes any sense......When installing the the new top mounts they were fitted directly on top of the top cap on the coilover is this correct? Wasnt sure if there should be somthing between the two as the fit didnt seem perfect?
  5. CanadianVR6
    Hey guys, after opting for coilovers over a spring and dampner kit, im hearing a creaking noise when steering at low speeds. Ive just installed the coilovers last weekend, and didnt notice the noise till a couple days after?? Anyone else experienced this?
  6. CanadianVR6
    Hey, ive just purchased a new gmax kit, and will be fitting it myself. Ive fitted kits on mk1&2 gtis before and was just wondering if doing the job on a vr6 is much diiferent or if theres any special tools needed? Any other handy tips would be greatly appriciated!
  7. CanadianVR6
    cheers guys!
  8. CanadianVR6
    Hey just wondering if any others have experienced this. When i start up in the morning or if it hasnt run for a while, theres are really noticleble whinning noise, it only lasts about 5 minutes then goes away, car idles fine and runs fine while driving... and noise dosnet reocur if started up again shortly after shutting it off... Any ideas? cheers
  9. CanadianVR6
    hey how exactly do u adjust the camber? my front drivers side looks out, as im having a hard time finding a place who does 4 wheel/camber alignments.
  10. CanadianVR6
    I live 20 minutes north of glasgow
  11. CanadianVR6
    Hey! not long after i bought my 98 vr6 my ABS light has come on and stays on. In order to have a diagnostics check on my car, do I have to go to a main VW garage to find out what is causing it, or will some privatly owned shops have the equipment to do it?
×
×
  • Create New...