c4mbl 1 Posted July 18, 2006 Report Share Posted July 18, 2006 Been looking at alloys for my car, came across alot of different figures ( :-p ). two that im not 100% sure on are: 5x100, and et35.Are those the right sizes i want to be going for or is it going to be something different??Ive checked the guide above but it doesnt mention anything about these.Cheers guys. Link to post Share on other sites
craggsy 91 Posted July 19, 2006 Report Share Posted July 19, 2006 5*100 is the PCD which is the bolt pattern and ET35 is the ofset which is a bit harder to explain. But if i remember as long as its between 35 and 38 it should be fine. But then you could use spacers and adapters if using other manufacturers wheels but thats another thing again Link to post Share on other sites
c4mbl 1 Posted July 19, 2006 Author Report Share Posted July 19, 2006 ah right yeh i understand now mate, i know what offset is, i just wasnt sure whether that figure (et) was relating to that or not.Cheers. Link to post Share on other sites
Recommended Posts