matth76 1 Posted February 25, 2006 Report Share Posted February 25, 2006 HiI'm thinking of buying some cold air feed ducting to replace the short bit that comes with the kit. How wide/what diameter will it need to be (in mm) exactly so it will fit nicely onto the end of the BMC?ThanksMatt Link to post Share on other sites
Seademon 0 Posted February 25, 2006 Report Share Posted February 25, 2006 Cant you measure the diameter of the short piece that you've got? Link to post Share on other sites
Petesvw 0 Posted February 25, 2006 Report Share Posted February 25, 2006 90mm i think Link to post Share on other sites
matth76 1 Posted February 25, 2006 Author Report Share Posted February 25, 2006 I haven't got the BMC yet...getting it fitted for free at Stealth next weekend when I have a rolling road session. However quite a few people have said the bit of ducting that comes with the kit is not long enough to wind down to the centre at the bottom of the engine bay so it can sit just behind the front bumper grill... the only way is to remove the carbon cannistor. Therefore I was looking at buying a longer piece of ducting hose to reach down to the bottom of the engine bay in the centre so it will sit right behind the front bumper. Is it 90mm? I had someone else tell me it may be 80mm. Need it to fit well on the bmc ideally.Thanks for any help.Cheers Link to post Share on other sites
Petesvw 0 Posted February 25, 2006 Report Share Posted February 25, 2006 Best P.M jezmoz, he bust his and had to get it replaced!The pipe you get with the BMC is corrigated, so it will streatch. But you can ditch the carbon can anywho. Link to post Share on other sites
Seademon 0 Posted February 26, 2006 Report Share Posted February 26, 2006 The pipe that comes with it though isnt very bendy at all tho! Link to post Share on other sites
ALean Mofo 0 Posted February 26, 2006 Report Share Posted February 26, 2006 Can you just ditch the carbon canister?Is it something straight forward to do?Thanks Link to post Share on other sites
Seademon 0 Posted February 26, 2006 Report Share Posted February 26, 2006 The carbon keeps the heat out and keeps the intake temp lower but depends what your trying to achieve Link to post Share on other sites
Recommended Posts