ebmurray 0 Posted June 29, 2005 Report Share Posted June 29, 2005 Anyone had any problems with theirs? I was on the M25 yesterday afternoon and depressed the clutch to change down a gear and it made big noise and then went right to the floor, where it stayed. I know they are hydraulic and there is a slave and master cylinder, I just wondered what else could go wrong! I had to get it towed to a garage and they are telling me that it isn't a cylinder because it has stayed depressed to the floor and it cannot be pulled back.Could it be a thrust bearing?Cheers,Ed Link to post Share on other sites
Seademon 0 Posted June 29, 2005 Report Share Posted June 29, 2005 Could be the release arm? They are about Link to post Share on other sites
ebmurray 0 Posted June 29, 2005 Author Report Share Posted June 29, 2005 Yeah it's only done 90K and is a P plate. Worth a look though, would that hold the pedal in place as well? Link to post Share on other sites
Seademon 0 Posted June 30, 2005 Report Share Posted June 30, 2005 Not too sure to be honest but it sounds possible - once that snaps/breaks the pedals going to be on the floor I reckon Link to post Share on other sites
Mangold 0 Posted July 17, 2005 Report Share Posted July 17, 2005 sounds like another clutch pedal has failed, sorry to hear it mate, know first hand what its like. New pedal is around Link to post Share on other sites
Nerih 0 Posted July 17, 2005 Report Share Posted July 17, 2005 that is a crap thing to happen m8.... Link to post Share on other sites
Recommended Posts