should be my last question, vr6 timing looks ok, but cam lobes look out of place?

[paceo 22]

first of all that you for your help on here!

 

the crank pulley and auxillery shaft timing marks are spot on on the corrado vr6 engine, the new schimmell 263 cams half moons also look spot on with the cam locking tool used, but if you look at the cam lobes there is a slight difference, ive marked it in red arrows so you can see, its only 2mm out i would say, but would it do any harm?

 

look at the rear lobes first ive marked with a red arrow, compared them to the blocks that hold the cams down, you can see a 2mm or so difference, also look at the lobes facing upwards, one is at about 12pm and the other at about 12.02pm