Atlas 12v 0 Posted May 27, 2005 Report Share Posted May 27, 2005 Going to fit a 60/40mm H&R Cup kit to my VR6 and need to know what length of bumpstop to use. I don't really want to use aftermarket as they're a bit to stiff. Ideally I'd like to use OE one and cut them down a little.Also anyone know the various torque amounts for each fixing point of the suspension ie top nut etc Link to post Share on other sites
dubloke 4 Posted May 27, 2005 Report Share Posted May 27, 2005 surely a kit from h&r will already come with bump stops to match? i would not be impressed if not. the nuts to torque are upper mount-46lbs, strut-swivel mount-46lbs.that should be all you need tbh! pm me if you need more! Link to post Share on other sites
acf8181 0 Posted May 28, 2005 Report Share Posted May 28, 2005 coilovers come with bumpstops, normal springs and dampers tend not to. just cut about 30-40mm off the o.e. stops i reckon. Link to post Share on other sites
Atlas 12v 0 Posted June 1, 2005 Author Report Share Posted June 1, 2005 I posted this on the Vortex forum and they said approx have of what I'm lowering by so 30mm front and 20mm rear. Sound about right.Do you recon these should be renewed aswell? Link to post Share on other sites
Recommended Posts