Russvrt 85 Posted July 15, 2014 Report Share Posted July 15, 2014 Ok I'm changing my obd1 turbo set up to obd2 ,everything is back in and plugged in but when I go to start the car it just turns over..I have power to the throttle body as that adjusts itself when the ignition is turned on,,I have spark but the fuel pump doesn't prime, and the red/ yellow injector wire has no power to it..If I jump the two large terminals in poss 12 fuel pump relay ,the pump runs,,I have the jumper wire in 30/30b,,,ecu pin 54 is live so what could be the problem ..?Please help! Link to post Share on other sites
daveyboy 897 Posted July 15, 2014 Report Share Posted July 15, 2014 Is the fuel pump relay not shagged then? Link to post Share on other sites
Russvrt 85 Posted July 15, 2014 Author Report Share Posted July 15, 2014 I've tried three of them. Run out of ideas. Link to post Share on other sites
Russvrt 85 Posted July 15, 2014 Author Report Share Posted July 15, 2014 Also think I have a bigger problem ,the throttle body clicks along with what sounds like cam sensor and battery light flickers ..This loom has been hacked at by a couple of people so might have to start again ,anyone got one cheap?. Link to post Share on other sites
Recommended Posts