D11PS 146 Posted February 22, 2014 Report Share Posted February 22, 2014 Evening chaps, I'm just doing some research to see what it would cost to rebuild an OBD2. What's I'm looking to do, -Port / gasflow the head -New pistons -Bottom end -Knife edge crank -Re- profile the cams or upgrade them -Oil cooler -Charge cooler Any help to the costing or recommendations of places to carry out the work or even products would be great. Thanks Sent from my iPhone using Tapatalk Link to post Share on other sites
Daverse 175 Posted February 22, 2014 Report Share Posted February 22, 2014 Not sure on gas flowing a head, i'd go for wossner or mahle pistons. Same brand or IE con rods. You'll have to find a engine place near you that does crank balancing e.t.c schimmel performance cams (263 are good for turbos), mocal oil cooler (pref thermostatic) chargecooler im not sure on, as im going custom, but heard very good things about the Schimmel kit. Sent from my GT-I9300 using Tapatalk Link to post Share on other sites
D11PS 146 Posted February 22, 2014 Author Report Share Posted February 22, 2014 Thanks do your reply, where would I be able to source a schimmel kit from? I should add more info as to why I'm looking to do the work, it's running a vortech charger and wanted to do the VR justice Sent from my iPhone using Tapatalk Link to post Share on other sites
Daverse 175 Posted February 22, 2014 Report Share Posted February 22, 2014 Spturbo.com Sent from my GT-I9300 using Tapatalk Link to post Share on other sites
D11PS 146 Posted February 22, 2014 Author Report Share Posted February 22, 2014 Thanks mate, I was just reading through his intro on his homepage.. All I can say is wow Link to post Share on other sites
Daverse 175 Posted February 22, 2014 Report Share Posted February 22, 2014 Yeah, you can soon start spending big bucks there just be wary to get eveeything in one go, as more often then not you have to pay customs to bring it overseas Sent from my GT-P5210 using Tapatalk Link to post Share on other sites
Recommended Posts