rsweeney 40 Posted August 16, 2011 Report Share Posted August 16, 2011 whats the torque setting for the driveshaft to gearbox ? for the six spline bolts. Really need this !! Link to post Share on other sites
bungy 2 Posted August 16, 2011 Report Share Posted August 16, 2011 For a 4motion it is the following.Pre-tighten to 10Nm diagonally and then to tighten at 70Nm = 52 ft-lb. I'm not sure if it is the same or not for a mk3. Link to post Share on other sites
rsweeney 40 Posted August 16, 2011 Author Report Share Posted August 16, 2011 thanks mark just seen your post , i ended up going to the garage that used to service it and was told 45Nm .but thanks for the reply i did the 10Nm thing , well to the same principle before fully tightning. Link to post Share on other sites
Recommended Posts