*P3nfold* 0 Posted May 7, 2011 Report Share Posted May 7, 2011 Hi all,Fitted the 2 silencer variant today and have a few issues,All the joints seem to be blowing a little, I used Exhaust Gum but it does not seem to work.Also I have noticed alot of fluid dripping out of the sleeves?Last point there is a bracket on the centre section that is for the 8v and this seems to be touching the top of the exhaust hanger, is this normal?Whats the options?Take it all apart again?Pull apart all the sleeves and use exhaust gum?Any advise or pointers would be great!! Link to post Share on other sites
bungy 2 Posted May 7, 2011 Report Share Posted May 7, 2011 I would always dry fit first and rotate pipes and push/pull to adjust. Scribe some witness marks and then remove to use paste if needed. My Miltek fitted well enough to not need paste. Link to post Share on other sites
HAMMER_VR6 0 Posted May 8, 2011 Report Share Posted May 8, 2011 i have a jetex and i cut the 8v exhaust hanger off with angle grinder because it used to knock and vibrate on the exhaust hanger, do that or it will do your head in. Otherwise great exhaust Link to post Share on other sites
*P3nfold* 0 Posted May 8, 2011 Author Report Share Posted May 8, 2011 Cheers Guys, all sorted took the lot off, cleaned all the joints, realised I got the middle bar wrong lolOh borrowed my mates impact gun, tighten up a little extra, slight blow but exhaust gum sorted that. Link to post Share on other sites
Recommended Posts