VR6Gill 1 Posted April 2, 2011 Report Share Posted April 2, 2011 Had the VR in this morning for new rear discs and pads front drivers ball joint and ABS sensor.Fitted the ABS sensor cleared the fault however no signal is being picked up.Any ideas what could be wrong / what needs replacing??Thanks in advance. Link to post Share on other sites
cabrioman 6 Posted April 5, 2011 Report Share Posted April 5, 2011 did the ABS rings get put back on the new rear discs ???? Link to post Share on other sites
VR6Gill 1 Posted April 5, 2011 Author Report Share Posted April 5, 2011 Yep... its the front drivers side.My mate put his Snap-on diagnostics checker and the fault is front right ABS sensor. We went for a drive and it was reading speed from all 3 wheels other than the front right. Link to post Share on other sites
cabrioman 6 Posted April 5, 2011 Report Share Posted April 5, 2011 either the pick up ring is missing or broken they sometimes crack and dont grip so they wont turn to give the signal or there is a broken wire somewhere in the loom Link to post Share on other sites
VR6Gill 1 Posted April 6, 2011 Author Report Share Posted April 6, 2011 Will check on the weekend thanks. Link to post Share on other sites
Recommended Posts