VR6_Absy 0 Posted November 17, 2010 Report Share Posted November 17, 2010 I've disconnected everything in the engine bay but before i start stripping out interior stuff anybody got advice on best way of removing the engine loom.Do i need to remove Dash ??Do i need to remove Master Cylinder for access ?Any help / advice greatly appreciatedCheersGary Link to post Share on other sites
cabrioman 6 Posted November 17, 2010 Report Share Posted November 17, 2010 do you want to keep the loom in tact ??? i removed the dash in mine when i went over to OBD2 and was easier as had more room to move around thing .... Link to post Share on other sites
VR6_Absy 0 Posted November 17, 2010 Author Report Share Posted November 17, 2010 yeah mate need to reuse after it's been spliced together with R32 loom.Looking at it scratching my head tonight there is no access beside brake servo Link to post Share on other sites
cabrioman 6 Posted November 17, 2010 Report Share Posted November 17, 2010 in that case then brake servo will need to come off mate .... no other way if you need to keep it in tact .... and the servo aint the most fun job .... good luck dude make sure you have a few cold ones in the fridge for afterwards lol Link to post Share on other sites
VR6_Absy 0 Posted November 17, 2010 Author Report Share Posted November 17, 2010 Cheers bud, well it's all been easy so far so it's about time i hit an awkward bit. Few more bits stripped out and laying about isn't going to hurt lol. Maybe i'll just leave them all out to reduce weight ;-) Link to post Share on other sites
cabrioman 6 Posted November 17, 2010 Report Share Posted November 17, 2010 like your thinking mate .... lol Link to post Share on other sites
Recommended Posts