T0NYVR6 2 Posted June 6, 2010 Report Share Posted June 6, 2010 O.K. so today I took the inlet pipe off and moddified it not to take the oil breather as the bottom pipe on the old breather pipe had split and was allowing air into the inlet. When I had A look I noticed there was quite alot of oily gunk inside the inlet so I checked the throttle body and that was the same.My question is this, How easy is it to remove the Throttle body and what is the best way to clean it? I cleaned around the throttle body as best I could but I'm afraid theres a load more crap in there that I cannot get to! Link to post Share on other sites
cabrioman 6 Posted June 6, 2010 Report Share Posted June 6, 2010 its only held on with 4 allen key bolts two coolant hoses and a plug ... easy to remove mate and use carb cleaner brings them up a treat but dont use anything sharp to remove the gunk ... Link to post Share on other sites
T0NYVR6 2 Posted June 6, 2010 Author Report Share Posted June 6, 2010 Thanks, what about the throttle cable, will that need setting up again if I take it off? Link to post Share on other sites
cabrioman 6 Posted June 6, 2010 Report Share Posted June 6, 2010 the throttle cable wont but u mite need to let it idle for about 5 mins to re set it self ... Link to post Share on other sites
T0NYVR6 2 Posted June 6, 2010 Author Report Share Posted June 6, 2010 OK cheers mate. Link to post Share on other sites
Recommended Posts