sparkyjr 0 Posted May 28, 2010 Report Share Posted May 28, 2010 When i purchased my vr the fuel gauge didnt work but fixed it , but my question is when i turn the ignition on it takes a while for it to register the correct amount of fuel. Is this normal and if not is there a way of fixing it ? Link to post Share on other sites
UnitedMotorsport 55 Posted May 28, 2010 Report Share Posted May 28, 2010 How long is a while? Link to post Share on other sites
sparkyjr 0 Posted May 28, 2010 Author Report Share Posted May 28, 2010 about five mins to show exact but will start moving in 30 secs Link to post Share on other sites
Bazra 0 Posted June 6, 2010 Report Share Posted June 6, 2010 hey sparky. i have just brought my vr6 and her fuel gauge is broken 2 (not registering anything). As u've said u fixed urs can ya giv me some pointers on where 2 start 2 sort it out please? thank ya. Link to post Share on other sites
sparkyjr 0 Posted June 6, 2010 Author Report Share Posted June 6, 2010 First thing u need to do is open up the top of the tank( which is in the boot a circular cap) then undo the sender unit. Make sure you mark the two fuel lines and pull these off ( the fuel is still under pressure so do it slow and be ready to mop it up) unless you depressureise it fist. I didn't need to take the pump out just sender unit and with a meter, meter out each cable to see if they are damaged. One of mine was broken so I simply crimped it back and it worked. If you need me to explain any bits of this further please let me know, good luck. Link to post Share on other sites
james4287 1 Posted June 6, 2010 Report Share Posted June 6, 2010 does your fuel needle on the gauge ever go on the maximum mark or just over it? no matter how much fuel i put in when i fill up i can never get it on the maximum mark on the gauge, is this normal? Link to post Share on other sites
Recommended Posts