wayne_1@tiscali.co.uk 27 Posted April 21, 2010 Report Share Posted April 21, 2010 does anybody know where to gain access to inject waxoil into the seals back arches and front floor pan thanks Link to post Share on other sites
bungy 2 Posted April 21, 2010 Report Share Posted April 21, 2010 Not sure on injection points but it all goes a lot easier if you warm it through before use. You can stand it in boiling hot water to warm it up. Link to post Share on other sites
ingham 5 Posted April 21, 2010 Report Share Posted April 21, 2010 i had a ford years ago that had been waxoiled from new they had drilled holes to get to some places and it had wax oil plugs to fill holes (small black grommets ) Link to post Share on other sites
Lukey. 381 Posted April 22, 2010 Report Share Posted April 22, 2010 there are body bungs all over, the rear aches are on the front of the arch at sill level, if you want to get to the tops of the arches youll have to take the rear cards off as theres polystyrene blocks blocking the tops off and the front floor are all under the car, some go straight into the inside of the car though and some are only accesible from inside with the carpet up.If you want to do the fronts of the outer sills you need to drill through the inner sill then bung it there is no access to it, the holes already there dont provide accessIt is miles easier if its warmed and dont try to extend the wand for more access, the wax sets in the tube before it gets to the end, its that long for a reason as i found out Link to post Share on other sites
Recommended Posts