Mark_H 0 Posted November 21, 2009 Report Share Posted November 21, 2009 Hi,I've just changed my suspension and would how you guys check the camber etc after changing the shocks and spring. I assume the set up will change as I'm not 100% sure that I put the two strut bolts back in the same position. Thanks,Mark Link to post Share on other sites
Phat VR6 3 Posted November 21, 2009 Report Share Posted November 21, 2009 you can't check over here fella.You can use a spirit level on the front sub frame. get the car level left to right.then use the spirit level on the hub face. use a jack to get the wishbone level (like it was on the floor) and adjust it that way.You might as well get it lazer tracked and camber. Its one of the most important parts of a well handling car Hope that helps Link to post Share on other sites
CALICO 130 Posted November 21, 2009 Report Share Posted November 21, 2009 4 wheel laser alignment the best way most accurate too Link to post Share on other sites
rodney 17 Posted November 21, 2009 Report Share Posted November 21, 2009 fit the suspension then drive around for no more than 30 miles so everything settles then....you're going to have to get your cast and cambers checked. No other way... The 4 wheel laser set-ups are great and usually no more than £50. Worth every penny. Link to post Share on other sites
Mark_H 0 Posted November 21, 2009 Author Report Share Posted November 21, 2009 thnaks guys....4 wheel laser alignment it is then.... Link to post Share on other sites
Recommended Posts