bungy 2 Posted September 25, 2009 Report Share Posted September 25, 2009 Is there a 6 branch exhaust manifold available for the 4 motion? I've been looking into making a decat pipe and it would be a lot easier/simpler if I had a 6 into 1, coupled to a flexi and onto a decat pipe and then my Milltek. Link to post Share on other sites
Eat this 2 Posted September 25, 2009 Report Share Posted September 25, 2009 give storm a ring they made mine for the 3.2l Link to post Share on other sites
VR6Rich 3 Posted September 28, 2009 Report Share Posted September 28, 2009 Miltek do one for the R32 which also fits the 2.8 ;-) Link to post Share on other sites
UnitedMotorsport 55 Posted September 28, 2009 Report Share Posted September 28, 2009 You cant run a 6 into 1 on a stock 4motion engine. This engine is run as 2 banks and each bank has its own lambda sensors. Link to post Share on other sites
bungy 2 Posted September 28, 2009 Author Report Share Posted September 28, 2009 I've had a closer look at the cat and will not be that hard to fabricate a decat pipe. So I think i'll be keeping the manifold and down pipe and making up a replacement. Anyone know the thread for the Lamda sensor? Is it the same as the VR6 and M12F? Link to post Share on other sites
UnitedMotorsport 55 Posted September 30, 2009 Report Share Posted September 30, 2009 Lambda probe thread is M18. Link to post Share on other sites
bungy 2 Posted October 10, 2009 Author Report Share Posted October 10, 2009 Good job I asked then. Cheers C2. Link to post Share on other sites
Recommended Posts