baz8328 0 Posted February 23, 2009 Report Share Posted February 23, 2009 Going to remove front and back bumpers to get them sprayed !Anyone know how they come of ?Any help would be muchly appreciated !!Msn Baz_coombs @ hotmail.comorBaz8328 @ ntlworld.com Link to post Share on other sites
rodney 17 Posted February 24, 2009 Report Share Posted February 24, 2009 not had to do a back one ever so someone else will need to help you. however the principle should be the same as the front.Remove the grill. Need a slim screwdriver for those clips. 3 on top 4 on bottom i think. I take all the lights off as it makes my life easy and it only takes a second or two... then you have a selection of bolts on top of the bumper 4 i think... Now for the fun bit. In the arches facing the front as you would expect if holding the bumper on. There is a little black plug connector thingy. It looks linda like a black rivet with a centre in it. You need to push the centre of it out. 2 each side i think -might be 3. So you need a strong slim pointy thing.TAKE CARE!!!!!!!! Dont loose it!!!!!!!! It will do its best to run for the hills, in fact it will insist on heading to the parallel dimension. If you loose it then you cant refit it Of course remember to unplug the temperature sensor in the bumper as well.Simple really....the numbers might be off a little as it has been a while since i had to do it.... Link to post Share on other sites
shail 0 Posted February 24, 2009 Report Share Posted February 24, 2009 Also - you need to remove screws holding under-engine plastic trays to the lower bumper splitter. Link to post Share on other sites
Recommended Posts