HIGHLINE VR6 1 Posted November 18, 2008 Report Share Posted November 18, 2008 ive got new pads and new discs. the rear wheel bearings are growling and so i have decided to change them.where should i get new bearings from, gsf or vw? and what other parts will i need to do job, someone mentioned to me about a abs ring?and what is the procedure for all this?very much appreciated, ian Link to post Share on other sites
ingham 5 Posted November 18, 2008 Report Share Posted November 18, 2008 its an easy job as long as the bolts that hold calliper carrier on come undone, be careful with abs rings,i would go to tps(trade parts service) for parts Link to post Share on other sites
Bigjobbo 0 Posted November 18, 2008 Report Share Posted November 18, 2008 Pack the bearings with loads of grease, and take your time knocking in the new race, try to use a cheap punch as i have chipped one using a snap-on punch. A race drift makes life a lot easier if you can get hold of one. I concur, TPS for bits. Link to post Share on other sites
Recommended Posts