russvr6 0 Posted October 1, 2008 Report Share Posted October 1, 2008 i have a 94 raddo vr it wont start from cold without pressing the accelerator after that it runs like crap and hesitates when putting your foot down. plugged it in to a snap-on diagnostics which came up with hall sensor and idle air circulation. i removed and cleaned the hall sensor but the problem is still there does anyone have any ideas Link to post Share on other sites
Karr-Man 0 Posted October 1, 2008 Report Share Posted October 1, 2008 i assume that u cleared the errors from the ecu when u plugged her in, did they come back after u cleaned up the sensor?? maybe u need a new one?also this should really be in the engine section...not interior;) Link to post Share on other sites
russvr6 0 Posted October 1, 2008 Author Report Share Posted October 1, 2008 no haven't plugged it back in yet just assumed it would run ok once the sensor was cleaned Link to post Share on other sites
Karr-Man 0 Posted October 1, 2008 Report Share Posted October 1, 2008 well imo thats the next thing to do, i assume u checked the sparks like i suggested and cleared the coilpack out of the equation??? Link to post Share on other sites
russvr6 0 Posted October 2, 2008 Author Report Share Posted October 2, 2008 yeah checked them they all have sparks getting it plugged in today to clear codes fingers crossed thats it Link to post Share on other sites
Karr-Man 0 Posted October 2, 2008 Report Share Posted October 2, 2008 plug it in and clear the codes - then drive it a bit and plug it back in to see if the codes have come back... Link to post Share on other sites
Recommended Posts