russvr6 0 Posted October 1, 2008 Report Share Posted October 1, 2008 i plugged my 94 raddo vr into a snap on diagnostics and it came up with idle speed regulation and hall sender but i was told that my vr with coil pack wouldn't have a hall sender is this true or is it called something else i.e cam sensor as i think this could be the cause of my problems Link to post Share on other sites
russvr6 0 Posted October 1, 2008 Author Report Share Posted October 1, 2008 i found the sensor cleaned it but the car still wont start from cold without the accerator pressed really haven't got a clue what to do someone please help Link to post Share on other sites
rigs 0 Posted October 2, 2008 Report Share Posted October 2, 2008 Does it run ok as long as you are using the pedal to hold idle? Rev freely etc....?I assume given you've got an idle control fault that you've checked the idle control valve? (assuming it's OBD1) Link to post Share on other sites
russvr6 0 Posted October 2, 2008 Author Report Share Posted October 2, 2008 it runs as long as you hold the peddle then it dies if you let go and it seems to hold back then let go when you put your foot down yes it is OBD1 i have cleaned the idle valve i have a new one coming tomorrow Link to post Share on other sites
russvr6 0 Posted October 2, 2008 Author Report Share Posted October 2, 2008 hi i have fixed it the filter from the damper box behind the isv had come through and clogged up the pipe to the isv thanks for everyones help Link to post Share on other sites
Recommended Posts