subby 0 Posted September 15, 2008 Report Share Posted September 15, 2008 When i put it in 1st gear it sometimes dont go in then sometimes it dose.Then when its in gear i can pull it side to side alot wot can it be down to and how can i fix this problem??Regards Subby Link to post Share on other sites
cabrioman 6 Posted September 15, 2008 Report Share Posted September 15, 2008 im guessin linkage mate .... can u get all gears ??? does it drive ok ??? .... Link to post Share on other sites
subby 0 Posted September 15, 2008 Author Report Share Posted September 15, 2008 yea i can get all gears but its like a dick in a bucket TBH it drives lovely but sometimes gets a crunch into gear Link to post Share on other sites
cabrioman 6 Posted September 15, 2008 Report Share Posted September 15, 2008 well its either clutch or gearlinkage mate ... try and take some pics of the top of ur gear box and post them on here mate mite be able to see wot wrong ?? Link to post Share on other sites
subby 0 Posted September 15, 2008 Author Report Share Posted September 15, 2008 kk mate ill get one in a min mate Link to post Share on other sites
subby 0 Posted September 15, 2008 Author Report Share Posted September 15, 2008 Here are the pictures of the gear box secter.When its in reverse there is no play. Link to post Share on other sites
cabrioman 6 Posted September 15, 2008 Report Share Posted September 15, 2008 well it looks like a new bolt on the change cable but apart from that .... is the balance weight secure ???? fault could be under the gator inside mate ??? check there , checked the rods etc Link to post Share on other sites
Toad 0 Posted September 15, 2008 Report Share Posted September 15, 2008 Is the side to side motion cable secure? Should go from top to bottom; Bolt, Cable, Washer, selector lever with nut inside. Link to post Share on other sites
subby 0 Posted September 15, 2008 Author Report Share Posted September 15, 2008 On top of the gearbox where the linkage gose it has place where the linkage meets the rod.The hole mecanisum all moves will that be worn bushes or just be a replace? Link to post Share on other sites
cabrioman 6 Posted September 15, 2008 Report Share Posted September 15, 2008 mite be a new mech mate dont know there are any bushes u can replace there but dont hold me too it lol Link to post Share on other sites
subby 0 Posted September 15, 2008 Author Report Share Posted September 15, 2008 i was told are they are some on the gear stick but ill re place the linkage and im looking at getting a B&M short shifter next week then ill find out if its still the same if so it will be the mech Link to post Share on other sites
Recommended Posts