john555 0 Posted March 15, 2008 Report Share Posted March 15, 2008 please can some body help me iv started fitting my vf engineering charger but cant work out a couple of things 1. do i need to do anything electrics wise other than exted then wires to the air flow meter and the chip2. were does the vaccum line that comes out of were the oil feed goes into the the charger connect to3. were abouts does the vaccum line from the bov conect Link to post Share on other sites
sparkz 0 Posted March 15, 2008 Report Share Posted March 15, 2008 1. No2. AFAIK, there isnt a vacuum line by the oil feed. can you post up a pic to clarify.3. Tee's off at the vacuum pipe on the right of the inlet mani between the fpr and the inlet mani.HTH Link to post Share on other sites
john555 0 Posted March 16, 2008 Author Report Share Posted March 16, 2008 ill get a pic im the morining but its got like a brass section on it and it goes into the same hole as were the oil feeds intohttp://www.vr6oc.com/e107_plugins/coppermine_menu/albums/userpics/14596/Supercharger%20resize.jpgthere is another vaccum line port on the compressor housing of the chager on the section just before the air leaves the charger what is that forthanks for the help sparkz your a life saver Link to post Share on other sites
john555 0 Posted March 16, 2008 Author Report Share Posted March 16, 2008 ok this isnt my charger but its the same there a port beside the blue imformation plate and one at the opposite side the one ate the opposite side has both a oil feed and a vaccum line on it??http://www.vr6oc.com/e107_plugins/coppermine_menu/albums/userpics/14596/Supercharger%20resize.jpg Link to post Share on other sites
john555 0 Posted March 16, 2008 Author Report Share Posted March 16, 2008 ok iv found a pic iv put some arows on can any one tell me if im right or wrong blue arrow oil feedred is the vaccum line coming from the copresor section of the charger around and into the port were the oil feed enters (blue arrow) Link to post Share on other sites
john555 0 Posted March 16, 2008 Author Report Share Posted March 16, 2008 http://i78.photobucket.com/albums/j88/john555_2006/charger.jpg Link to post Share on other sites
xyber 1 Posted March 16, 2008 Report Share Posted March 16, 2008 They are all oil lines, the line in goes to the blue block, which has a valve inside it and then runs acroos to the oppsite side if the charger like in the picwith the vacuum line for the bov, i hooked mine onto the brake booster line on the right hand side of the engine, it has a green cap on a port that is not used, just took the cap off and connected it Link to post Share on other sites
john555 0 Posted March 16, 2008 Author Report Share Posted March 16, 2008 thanks for the help ill run mine off that then Link to post Share on other sites
Recommended Posts